Which command will a network engineer issue to verify the configured hello and dead timer intervals on a point-to-point WAN link between two routers that are running OSPFv2?

Which command will a network engineer issue to verify the configured hello and dead timer intervals on a point-to-point WAN link between two routers that are running OSPFv2?

  • show ip ospf neighbor
  • show ip ospf interface serial 0/0/0
  • show ipv6 ospf interface serial 0/0/0
  • show ip ospf interface fastethernet 0/1
    Answers Explanation & Hints:

    The show ip ospf interface serial 0/0/0 command will display the configured hello and dead timer intervals on a point-to-point serial WAN link between two OSPFv2 routers. The show ipv6 ospf interface serial 0/0/0 command will display the configured hello and dead timer intervals on a point-to-point serial link between two OSPFv3 routers. The show ip ospf interface fastethernet 0/1 command will display the configured hello and dead timer intervals on a multiaccess link between two (or more) OSPFv2 routers. The show ip ospf neighbor command will display the dead interval elapsed time since the last hello message was received, but does not show the configured value of the timer.

For more question and answers:

Click Here CCNA3 v7 – ENSA – Modules 1 – 2: OSPF Concepts and Configuration Exam Answers Full 100%

Leave a comment