CCNA2 Chapter 2 Exam - Online Assessment
Quiz-summary
0 of 26 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
Information
CCNA2 Chapter 2 Exam – Online Assessment
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 26 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- Answered
- Review
-
Question 1 of 26
1. Question
What are two advantages of static routing over dynamic routing? (Choose two.)Correct
Incorrect
-
Question 2 of 26
2. Question
Refer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?
CCNA2 v6.0 Chapter 2 Exam 003
Correct
Incorrect
-
Question 3 of 26
3. Question
What is the correct syntax of a floating static route?
Correct
Incorrect
-
Question 4 of 26
4. Question
What is a characteristic of a static route that matches all packets?Correct
Incorrect
-
Question 5 of 26
5. Question
What type of route allows a router to forward packets even though its routing table contains no specific route to the destination network?Correct
Incorrect
-
Question 6 of 26
6. Question
Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?Correct
Incorrect
-
Question 7 of 26
7. Question
A company has several networks with the following IP address requirements:
IP phones – 50
PCs – 70
IP cameras – 10
wireless access points – 10
network printers – 10
network scanners – 2Which block of addresses would be the minimum to accommodate all of these devices if each type of device was on its own network?
Correct
Incorrect
-
Question 8 of 26
8. Question
What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state?Correct
Incorrect
-
Question 9 of 26
9. Question
The network administrator configures the router with the ip route 172.16.1.0 255.255.255.0 172.16.2.2 command. How will this route appear in the routing table?Correct
Incorrect
-
Question 10 of 26
10. Question
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
CCNA2 v6.0 Chapter 2 Exam 001
Correct
Incorrect
-
Question 11 of 26
11. Question
Which type of static route that is configured on a router uses only the exit interface?Correct
Incorrect
-
Question 12 of 26
12. Question
Refer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?
CCNA2 v6.0 Chapter 2 Exam 005
Correct
Incorrect
-
Question 13 of 26
13. Question
Refer to the exhibit. The network administrator needs to configure a default route on the Border router. Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?
CCNA2 v6.0 Chapter 2 Exam 004
Correct
Incorrect
-
Question 14 of 26
14. Question
What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.)Correct
Incorrect
-
Question 15 of 26
15. Question
Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?
CCNA2 v6.0 Chapter 2 Exam 009
Correct
Incorrect
-
Question 16 of 26
16. Question
Refer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?
CCNA2 v6.0 Chapter 2 Exam 008
Correct
Incorrect
-
Question 17 of 26
17. Question
Consider the following command:
ip route 192.168.10.0 255.255.255.0 10.10.10.2 5
Which route would have to go down in order for this static route to appear in the routing table?
Correct
Incorrect
-
Question 18 of 26
18. Question
Refer to the exhibit. The routing table for R2 is as follows:
Gateway of last resort is not set
10.0.0.0/30 is subnetted, 2 subnets
C 10.0.0.0 is directly connected, Serial0/0/0
C 10.0.0.4 is directly connected, Serial0/0/1
192.168.10.0/26 is subnetted, 3 subnets
S 192.168.10.0 is directly connected, Serial0/0/0
C 192.168.10.64 is directly connected, FastEthernet0/0
S 192.168.10.128 [1/0] via 10.0.0.6What will router R2 do with a packet destined for 192.168.10.129?
CCNA2 v6.0 Chapter 2 Exam 002
Correct
Incorrect
-
Question 19 of 26
19. Question
A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?Correct
Incorrect
-
Question 20 of 26
20. Question
Consider the following command:
ip route 192.168.10.0 255.255.255.0 10.10.10.2 5
How would an administrator test this configuration?
Correct
Incorrect
-
Question 21 of 26
21. Question
Refer to the exhibit. The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue?
CCNA2 v6.0 Chapter 2 Exam 007
Correct
Incorrect
-
Question 22 of 26
22. Question
Which three IOS troubleshooting commands can help to isolate problems with a static route? (Choose three.)Correct
Incorrect
-
Question 23 of 26
23. Question
An administrator issues the ipv6 route 2001:db8:acad:1::/32 gigabitethernet0/0 2001:db8:acad:6::1 100 command on a router. What administrative distance is assigned to this route?Correct
Incorrect
-
Question 24 of 26
24. Question
Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?
CCNA2 v6.0 Chapter 2 Exam 006
Correct
Incorrect
-
Question 25 of 26
25. Question
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.
Why are the pings from PC0 to Server0 not successful?
Correct
Incorrect
-
Question 26 of 26
26. Question
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.
What IPv6 static route can be configured on router R1 to make a fully converged network?
Correct
Incorrect