Answer – CCNA2 v6.0

CCNA2 v6.0 Chapter 10 Exam Full 2017 100% 1. Question A ping fails when performed from router R1 to directly connected router R2. The network administrator then proceeds to issue the show cdp neighbors command. Why would the network administrator issue this command if the ping failed between the two routers?  The network administrator suspects […]
Continue reading…

CCNA2 v6.0 Chapter 9 Exam Full 2017 100% 1. Question What is the primary purpose of NAT?  conserve IPv4 addresses  increase network security  allow peer-to-peer file sharing  enhance network performance 2. Question Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts?​  It uses the destination TCP or […]
Continue reading…

CCNA2 v6.0 Chapter 8 Exam Full 2017 100% Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server?  unicast DHCPACK  broadcast DHCPACK  unicast DHCPREQUEST  broadcast DHCPREQUEST 2. Question A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is […]
Continue reading…

CCNA2 v6.0 Chapter 7 Exam Full 2017 100% 1. Question In which configuration would an outbound ACL placement be preferred over an inbound ACL placement?  when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface  when a router has more than one […]
Continue reading…

CCNA2 v6.0 Chapter 6 Exam Full 2017 100% 1. Question What are three primary benefits of using VLANs? (Choose three.)  security  a reduction in the number of trunk links  cost reduction  end user satisfaction  improved IT staff efficiency  no required configuration 2. Question Which type of VLAN is used to designate which traffic is untagged […]
Continue reading…

CCNA2 v6.0 Chapter 5 Exam Full 2017 100% 1. Question Which statement describes the port speed LED on the Cisco Catalyst 2960 switch?  If the LED is green, the port is operating at 100 Mb/s.  If the LED is off, the port is not operating.  If the LED is blinking green, the port is operating […]
Continue reading…

CCNA2 v6.0 Chapter 4 Exam Full 2017 100% 1. Question A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)  lower bandwidth requirements […]
Continue reading…

CCNA2 v6.0 Chapter 3 Exam Full 2017 100% 1. Question Which dynamic routing protocol was developed to interconnect different Internet service providers?  BGP  EIGRP  OSPF  RIP 2. Question Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?  OSPF  RIP  EIGRP  IS-IS 3. Question What two tasks […]
Continue reading…

CCNA2 v6.0 Chapter 2 Exam Full 2017 100% 1. Question What are two advantages of static routing over dynamic routing? (Choose two.)  Static routing is more secure because it does not advertise over the network.  Static routing scales well with expanding networks.  Static routing requires very little knowledge of the network for correct implementation.  Static […]
Continue reading…

1. Question A network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed into?  flash  RAM  NVRAM  ROM 2. Question Which packet-forwarding method does a router use to make switching decisions when it is using a forwarding information base and an adjacency table?  fast switching  Cisco Express […]
Continue reading…