188.8.131.52 Packet Tracer – Troubleshooting Enterprise Networks 3
Packet Tracer – Troubleshooting Enterprise Networks 3 (Answer Version)
Answer Note: Red font color or Gray highlights indicate text that appears in the Answer copy only.
|Device||Interface||IP Address||Subnet Mask||Default Gateway|
|S1||VLAN10||DHCP assigned||DHCP assigned||DHCP assigned|
|PC1||NIC||DHCP assigned||DHCP assigned||DHCP assigned|
This activity uses a variety of technologies you have encountered during your CCNA studies, including routing, port security, EtherChannel, DHCP, NAT, PPP, and Frame Relay. Your task is to review the requirements, isolate and resolve any issues, and then document the steps you took to verify the requirements.
Note: This activity begins with a partial score.
- R1 is the DHCP server for the R1 LAN.
- Port security is configured to only allow PC1 to access S1’s F0/3 interface. All violations should disable the interface.
- Link aggregation using EtherChannel is configured on S2, S3, and S4.
- All routers are configured with OSPF process ID 1 and no routing updates should be sent across interfaces that do not have routers connected.
- R2 is configured with a default route pointing to the ISP and redistributes the default route.
- NAT is configured on R2 and no untranslated addresses are permitted to cross the Internet.
- The serial link between R1 and R2 uses Frame Relay.
- The serial link between R2 and R3 uses HDLC encapsulation.
- The serial link between R1 and R3 uses PPP with PAP.
- Devices should be configured according to the Addressing Table.
- Every device should be able to ping every other device.
|R1||There is an incorrect default gateway in DHCP pool||ip dhcp pool Access
|R1||The default route propagation should not be configured on this router||router ospf 1
no default-information originate
|R2||The default route propagation should be configured on this router||router ospf 1
|R2||Incorrect encapsulation on S0/0/1||interface s0/0/1
|R3||R3 is not forming an adjacency with R1 and R2||router ospf 1
no passive-interface default
|S1||Port security was configured on the incorrect interface||interface FastEthernet0/3
switchport access vlan 10
switchport mode access
switchport port-security mac-address sticky
|S3||Interface G1/1 switchport is not configured as a trunk port||interface g1/1
switchport mode trunk
|S4||Port channels are configured incorrectly||interface range f0/1-2
no channel-group 3 mode auto
channel-group 2 mode auto
interface range f0/3-4
no channel-group 2 mode auto
channel-group 3 mode auto
Capture output from verification commands and provide documentation proving that each of the requirements has been satisfied.
Answer’s Note: The answer key for this section is left blank because there are many ways to verify the requirements.
Suggested Scoring Rubric
Packet Tracer scores 60 points. The troubleshooting documentation and Answer verification is worth 40 points.